
New roofs installed by a licensed, insured Ward County crew
Roof Installation Surrey ND Built for North Dakota Weather
Roof Installation Surrey ND means a roof that sheds hail, holds up to 60 mph prairie wind, and keeps your attic dry through -30F nights. We install asphalt shingles, standing seam metal, and flat-membrane systems on homes and shops across Surrey and Ward County. Whether you are replacing a storm-battered roof or roofing new construction, we tear off, deck-check, and install to code with a manufacturer-backed warranty.
What's included
What a Full Roof Installation Includes
Every installation we do is a complete roof system, not just shingles nailed over whatever was there. Here is what is covered in a standard Surrey installation, and what we quote separately if your roof needs it.
Full Tear-Off and Disposal
We strip the old roof down to the deck, including every layer if there is more than one, and haul it all to the landfill. Dump fees are in the quote. You do not come home to a dumpster sitting in the driveway for a week.
Deck Inspection and Repair
We check the sheathing for rot, delamination, and nail pops with a moisture meter. Any panel that will not hold a fastener gets replaced and the price is agreed before we install over it. A new roof over a soft deck is money wasted.
Underlayment and Ice Shield
Synthetic underlayment goes across the whole field, with ice and water shield at the eaves, valleys, and any low-slope transition. That is the layer that saves you when an ice dam backs water up under the shingles in February.
New Flashing and Ventilation
New roof flashing at walls, chimneys, and skylights, plus new pipe boots and a ridge vent balanced with your soffit intake. We do not reuse old flashing and we do not skip ventilation, because both are leak and moisture sources.
Finish Roof and Warranty
Architectural shingles, standing seam metal, or membrane, installed to the manufacturer's pattern with a roofing nail gun and finished with ridge caps. We register the manufacturer warranty and hand you the paperwork at the final walk.
Service overview
What Roof Installation Surrey ND Actually Involves
Roof Installation Surrey ND is the full tear-off and replacement of your roof system, not a patch job. We strip the old shingles with a shingle ripper, inspect the deck for rot and nail pops, then rebuild the layers that keep water out: ice and water shield at the eaves and valleys, synthetic roof underlayment across the field, new roof flashing at every wall and chimney, and ridge vents for attic airflow. Then the finish goes on, whether that is architectural shingles, standing seam metal, or a TPO membrane on a low-slope section.
Surrey sits in Ward County where hail season runs May through August and freeze-thaw cycles work on every fastener from October to April. A roof that was fine three summers ago can be granule-bare and leaking at the pipe boots by fall. If you are searching for new roof installation near me in Surrey, you are usually dealing with missing shingles, ice dams, or a ceiling stain that showed up after the last storm. We handle all of it, from a single-family ranch to a shop with a flat roof.
The service timeline
How Our Roof Installation Process Works
The process flexes to the condition, but these checkpoints keep decisions clear.
Free Inspection
We walk the roof, check the deck from the attic side where we can, and photograph the problem areas: granule loss, flashing leaks, soft spots, chimney leaks. You get a written scope and a price before anyone touches a shingle. Most inspections take 45 to 60 minutes.
Material Selection
We lay out your options side by side: asphalt shingles versus standing seam metal, standard versus impact-rated, and the color samples that actually look right on your house. You pick the system and the warranty tier. We order materials so they land the day before tear-off, not the day of.
Tear-Off and Deck Check
The crew strips the old roof down to the deck, usually in one day on a standard ranch. We pull every nail with pry bars and a shingle ripper, then check the sheathing for rot with a moisture meter. Rotted panels get replaced before anything new goes down.
Installation Day
Ice and water shield goes at the eaves and valleys, underlayment across the field, then flashing at walls, chimneys, and skylights. Shingles or metal panels go on next, set with a roofing nail gun to the manufacturer's pattern. Ridge vents and pipe boots finish it. Most homes are dried in within two to three days.
Final Walk and Cleanup
We run a magnetic sweeper over the lawn, driveway, and flower beds to catch stray nails, then walk the finished roof with you. You get photos of the deck, the flashing details, and the warranty paperwork. If anything looks off in the first year, you call us, not a call center.
Tools & methods
Tools and Methods We Use on Every Roof
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Roofing nail gun
Sets shingle fasteners at the correct depth and pattern so they hold without cutting through the shingle mat. Consistent nailing is what makes a manufacturer warranty valid.
Shingle ripper and pry bar
Strips old shingles and pulls embedded nails without tearing up the deck. Clean tear-off is how we find rot instead of covering it.
Moisture meter and infrared camera
Finds wet sheathing and hidden leaks before we install new material over them. A soft deck panel that looks fine from above shows up immediately on the meter.
Chalk line and roofing hammer
Lays out straight courses and sets ridge caps and detail work by hand where a nail gun will not reach. Straight lines are not cosmetic; they keep water moving off the roof.
Safety harness and roofing ladder
Keeps our installers tied off on steep pitches and gives stable access to the ridge. We work to OSHA 10-Hour Construction standards on every job.
Magnetic sweeper
Runs over the lawn, driveway, and landscaping at the end of the job to pick up stray nails. We sweep twice, because a flat tire is not the way you want to remember your new roof.
Use cases
When Surrey Homeowners Call Us for Installation
These examples show how the service framework adapts rather than forcing every call through one repair.

Flat Shop Roof in Cloverdale
A shop with a patched modified bitumen roof that ponded at one corner and leaked into the insulation every time it rained hard. Previous repairs were caulk over seams, and none of them lasted a winter. → We installed a new TPO membrane system with proper slope to the drain, heat-welded seams, and new perimeter flashing. Two full spring melt seasons later, the ceiling is dry and the ponding is gone.
Storm Replacement in South Surrey
A windstorm lifted ridge caps and tore shingles off the west slope. The homeowner had shingles in the yard, a tarp on the roof, and an insurance adjuster coming in three days. → We documented the damage with photos, worked with the adjuster, and installed a full impact-rated shingle system with new flashing and ventilation. The claim covered the replacement and the new roof carries a registered manufacturer warranty.
Problems we solve
Roof Problems We Solve Before They Get Worse
Most roofs do not fail all at once. They give you warnings for a season or two, and the homeowners who catch them early avoid the interior damage and the emergency call.
Hail-bruised shingles with bare spots
We document the hail damage with photos, work with your insurance adjuster, and install a new impact-rated shingle system. The new roof carries a manufacturer warranty and a fresh deck underneath it.
Ice dams backing water under the shingles
A proper installation fixes the cause: ice and water shield at the eaves, correct attic insulation and ventilation, and sealed penetrations. We also check the gutters, because overflow makes ice dams worse.
Chimney and flashing leaks
We rebuild the step and counter-flashing during the installation, seal it correctly, and replace any rotted deck panels we find. Flashing leaks stop being a yearly caulk-and-hope routine.
Wind-lifted ridge caps and missing shingles
We re-fasten or replace the ridge, install to the correct wind zone for Ward County, and use the manufacturer's nailing pattern. The new roof is fastened to hold, not just to look finished.
Pricing process
What Roof Installation Costs in Surrey
$9,500 - $18,000 for asphalt shingles; $20,000+ for metal or complex roofs
Roof size and pitch
Square footage drives material cost, and steep pitches slow the crew down and require more safety setup. A simple ranch and a steep two-story with dormers are very different jobs even at the same square footage.
Number of existing layers
One layer tears off in a day. Two or three layers add labor and dump fees, and they often hide deck damage that only shows up once the old roof is stripped. We quote tear-off by the layer.
Deck condition
Rotted or delaminated sheathing has to be replaced before anything new goes down. We check with a moisture meter and price panel replacement per sheet, so you are paying for what is actually there.
How much does roof installation cost in Surrey ND?
Most asphalt shingle installations in Surrey run $9,500 to $18,000 for a typical 1,500 to 2,200 square foot home in 2026, and metal systems run higher. The price swings on roof pitch, how many layers get torn off, deck condition, and whether you add ventilation or skylight work. We give you a written number after the inspection, and it does not move unless we find rot once the old roof is off.
How long does a new roof installation take in Surrey North Dakota?
A standard ranch or two-story home is torn off and dried in within two to three working days, weather permitting. Larger homes, steep pitches, or metal roofs can run four to five days. We schedule around rain and high wind, because shingles will not seal below about 40F and crews do not go up in gusts over 30 mph.
What is the best roofing material for installation in Surrey ND?
Impact-rated architectural asphalt shingles are the best value for most Surrey homes because they handle hail and carry a longer warranty than standard three-tab. Standing seam metal lasts longer and sheds snow well, but costs roughly two to three times more upfront. For flat or low-slope sections, we install TPO or EPDM membrane. We walk you through the trade-offs in person.
Does roof installation in Surrey, North Dakota include a warranty?
Yes. Every full installation carries a manufacturer warranty on materials plus our own workmanship coverage, and we register the manufacturer portion for you. As a GAF Master Elite and Owens Corning Preferred Contractor we can offer extended system warranties that cover the whole roof assembly, not just the shingles. You get the paperwork at the final walk.
Ready when you are
Get Your Roof Installation Surrey ND Quote Today
One call gets a licensed, insured crew on your roof with a written scope and a firm price. We answer at 844-710-0795, schedule same-day estimates when we can, and stand behind every installation with a registered manufacturer warranty.

Talk with the local team
Request Roof Installation
Call us at +18447100795 or email info@surreyroofrepair.com. We answer the phone 24/7 for emergencies and schedule regular inspections within one business day. If you have photos of the damage, send them over and we can often give you a ballpark before we arrive.


