Fascia and Soffit Repair

Rotten boards replaced, soffits sealed, and your roofline made solid again

Fascia and Soffit Repair Surrey ND You Can Count On

Fascia and Soffit Repair Surrey ND stops the rot before it reaches your rafters. We handle fascia board repair in Surrey for homeowners dealing with peeling paint, soft wood, and water staining along the roofline. Whether it is hail damage, ice dams, or years of North Dakota freeze-thaw cycles, we replace what is rotten and seal what is sound. Same-week scheduling, upfront pricing, and a written warranty on every repair.

Live phone supportUpfront optionsBacked workmanship
Call firstLive triage can help before arrival
Safety before speedRisks assessed before work begins
Diagnose the causeWe trace the source, not just the symptom
Approve the repairScope and price explained upfront

What's included

What Our Fascia and Soffit Repair Includes

Every job is scoped to your roofline, but here is what is standard on a Surrey fascia and soffit repair. Anything outside this list gets priced separately and approved by you before we start.

01

Full Roofline Inspection

We walk the entire roofline, not just the section you called about. Moisture meter and infrared camera check every board. You get photos and a written scope of what needs repair and what can wait.

02

Rotten Board Removal

We pull the gutter run, cut out every soft section back to solid wood, and haul the old board away. Rafter tails get probed and tagged so you can see exactly what failed and why.

03

New Fascia Board Install

We install new fascia board sized to match your existing trim, caulk every joint with exterior sealant, and set the bottom edge with a chalk line so the gutter line stays dead straight.

04

Soffit Panel Replacement

Cracked, missing, or pest-damaged soffit panels get replaced with matching vented panels. We seal the gaps with the correct mesh so wildlife stays out but attic airflow stays open.

05

Priming and Painting

Every cut edge and nail head gets exterior primer, then the new boards get a finish coat matched to your trim color. Bare wood fails fast in North Dakota, so we do not skip this step.

06

Gutter Re-Hang and Cleanup

The gutter goes back up with new hangers, checked for pitch with a level. We run a magnetic sweeper over the lawn and driveway, and leave the jobsite cleaner than we found it.

Service overview

Fascia and Soffit Repair Surrey ND Done Right

Fascia and Soffit Repair Surrey ND is the work of replacing or reinforcing the horizontal boards that cap your rafter ends, plus the underside panels that vent and close off your roof overhang. The fascia carries your gutters, so when it softens, everything above it starts to sag. The soffit keeps pests, moisture, and wind-driven rain out of the attic cavity. We pull the gutter run, cut out the rotted sections, treat the exposed rafter tails, and install new fascia board and soffit panels that match your existing trim line.

Surrey homeowners call us most often after a hard winter. Ice dams push water up under the shingles, and that water sits against the fascia board for weeks. By spring, the paint is bubbling and a pry bar sinks into the wood like a spoon into wet cake. We also see fascia rot from gutter overflow, clogged downspouts, and hail damage that cracked the paint film. If you have been searching for fascia board repair near me Surrey, we cover every neighborhood in Ward County and the surrounding towns.

Stop Rot at the SourceRotten fascia spreads into the rafter tails and roof deck. We cut back to solid wood, treat the exposed end grain, and install new fascia board so the decay has nowhere left to travel. Catching it early saves you from a full roof deck replacement.
Protect Your GuttersYour gutters hang off the fascia. When that board softens, the gutter pulls away from the house and dumps water against your foundation. We re-secure the gutter run with new spikes and hangers after the fascia is solid, so the whole system drains where it should.
Keep Pests Out of the AtticCracked or missing soffit panels give squirrels, bats, and wasps an open door. We replace damaged soffit panels and seal the vent gaps with the correct mesh, so your attic stays closed to wildlife without blocking airflow.
Roofing Contractor for Surrey homes
How we workWe verify the cause, compare realistic options, and confirm the repair before we leave.

The service timeline

How Our Fascia and Soffit Repair Process Works

The process flexes to the condition, but these checkpoints keep decisions clear.

01

Inspection and Moisture Mapping

We walk the roofline with a roofing ladder and safety harness, then test suspect boards with a moisture meter. An infrared camera picks up hidden damp pockets behind the paint. You get photos of every soft spot and a written scope before we touch a board. Most inspections take 45 minutes.

Stage 1
02

Gutter Drop and Board Removal

We detach the gutter run and set it aside on the ground. A shingle ripper and pry bar pull the old fascia board without tearing up the drip edge. Rotted sections go straight into the dump trailer. We tag any rafter tail that needs sistering so you can see exactly what failed.

Stage 2
03

Rafter Repair and Treatment

Exposed rafter tails get cut back to solid wood and treated with a borate-based preservative. Where the tail is too far gone, we sister on a new segment with a roofing nail gun and structural screws. This is the step that stops the rot from coming back in two years.

Stage 3
04

New Fascia and Soffit Install

We install new fascia board, caulk every joint with a paintable exterior sealant, and fit new soffit panels with the correct vent pattern. A chalk line keeps the bottom edge dead straight. The gutter goes back up with new hangers, and we check the pitch with a level before we leave.

Stage 4
05

Paint, Cleanup, and Walk-Through

Cut edges and nail heads get primed, then the new boards get a finish coat to match your trim. A magnetic sweeper runs the lawn and driveway for stray nails. We walk the roofline with you, hand over the warranty paperwork, and answer any questions on the spot.

Stage 5

Tools & methods

Tools and Methods We Use on Every Repair

Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.

01

Moisture Meter and Infrared Camera

We test every suspect board with a pin-type moisture meter and scan the roofline with an infrared camera to find hidden damp pockets behind intact paint. This is how we catch rot before it reaches the rafter tails.

02

Shingle Ripper and Pry Bar

A shingle ripper slides under the drip edge to free the old fascia board without tearing up the shingles above it. The pry bar handles the stubborn sections and lets us check the rafter tail behind the board.

03

Roofing Nail Gun and Roofing Hammer

We fasten new fascia board and sistered rafter tails with a roofing nail gun set to the correct depth, then hand-set any nails that need a roofing hammer. Proper fastening is what keeps the board from pulling loose under snow load.

04

Caulking Gun with Exterior Sealant

Every joint between new and old board gets a bead of paintable exterior sealant. This stops water from wicking into the end grain, which is where fascia rot almost always starts.

05

Chalk Line and Roofing Ladder

A chalk line keeps the bottom edge of the new fascia dead straight, so the gutter line stays level. The roofing ladder gets us safe access to the eave without leaning a step ladder against the gutter.

06

Safety Harness and Magnetic Sweeper

Every crew member works in a safety harness on the roof. At the end of the day, a magnetic sweeper runs the lawn and driveway to pick up stray nails before anyone walks barefoot.

Use cases

When Surrey Homeowners Call Us for Fascia Repair

These examples show how the service framework adapts rather than forcing every call through one repair.

Fascia and Soffit Repair
Ice Dam Rot on a Whalley Ranch HomeA 1960s ranch home in Whalley had 28 feet of soft fascia along the north eave. The paint was bubbling, the gutter had pulled away six inches, and a pry bar sank into the board. Two rafter tails were rotted back four inches. → We cut out the failed board, sistered both rafter tails, and installed new primed fascia board. The gutter went back up with new hangers and a checked pitch. Total job took two days, and the repair matched the original trim color.

Storm-Damaged Soffit in South Surrey

A hailstorm cracked six soffit panels above a South Surrey garage and knocked the paint off 12 feet of fascia. Squirrels had already found the opening and were nesting in the attic insulation. → We replaced all six panels with matching vented soffit, sealed the edges with mesh, and replaced the damaged fascia board. The attic was closed to wildlife, and airflow was restored to manufacturer spec.

Gutter Pull-Off in Guildford

Heavy snow load pulled a 40-foot gutter run off a Guildford two-story. The fascia behind it was cracked at every fastener and soft along the bottom edge. Water had been dumping against the foundation for months. → We dropped the gutter, replaced the full 40-foot fascia run, sistered three rafter tails, and re-hung the gutter with hangers spaced for snow load. The foundation stayed dry through the next spring melt.

Problems we solve

Fascia and Soffit Problems We Fix in Surrey

These are the calls we get most often from Surrey homeowners. If any of these sound familiar, the damage is already spreading behind the paint.

ISSUE

Soft, spongy fascia board along the roofline

We probe the board with an awl and a moisture meter. Anything soft gets cut out and replaced with new fascia board, and the exposed rafter tails get treated with a borate preservative so the rot does not return.

SYMPTOM

Peeling paint and bubbling trim on the fascia

We scrape back the failed paint, test the wood, and replace any board that has gone soft. New boards get primed on every cut edge and face before the finish coat, so the repair holds through the next ten winters.

SIGN

Soffit panels cracked or missing after a storm

We replace the damaged panels with matching vented soffit, seal the edges with the correct mesh, and check the fascia above for water damage while we are up there.

ALERT

Gutter sagging away from the roofline

We remove the gutter, replace the failed fascia board behind it, and re-hang the run with new hangers spaced for North Dakota snow loads. Pitch gets checked with a level before we leave.

Pricing process

What Fascia and Soffit Repair Costs in Surrey

$450 - $1,800 for most residential repairs; $1,400 - $2,600 for full-house fascia and soffit replacement

Phase 01

Linear footage of fascia

Fascia is priced per linear foot. A 20-foot run costs far less than a 100-foot full-house replacement. We measure the actual roofline during inspection, so the quote reflects your house, not a square-foot guess.

Phase 02

Number of rafter tails

Every rotted rafter tail adds $40 to $90 to the job. We probe each tail during inspection and list them individually on the quote, so you know exactly what you are paying for.

Phase 03

Soffit panel count

Soffit is priced per panel. Cracked or missing panels add to the total, and vented panels cost slightly more than solid ones. We match the existing vent pattern so the repair blends in.

Questions before we arrive

Frequently Asked Questions About Fascia and Soffit Repair in Surrey

Fascia and Soffit Repair
Call +18447100795
How much does fascia and soffit repair cost in Surrey ND?

Most residential jobs in Surrey run $450 to $1,800 in 2026, depending on linear footage and how much rafter repair is needed. A single 20-foot run of fascia replacement with paint typically lands around $600 to $900. Full-house fascia and soffit replacement on a 1,500-square-foot ranch home usually falls between $1,400 and $2,600. Rafter tail repair adds $40 to $90 per tail. We give you a written, itemized quote before any work starts.

What causes fascia board rot in Surrey North Dakota?

Ice dams are the number one cause here. Water backs up under the shingles, sits against the fascia for weeks, and soaks into the end grain. Clogged gutters and overflowing downspouts are a close second. Hail damage that cracks the paint film lets moisture straight into the wood. On older Surrey homes, we also find rot from years of deferred paint maintenance. Once the paint fails, bare wood wicks up every rain and snowmelt.

Can you repair fascia without replacing it in Surrey ND?

Sometimes, yes. If the rot is surface-level and the wood is still solid when we probe it with an awl, we can scrape, treat with a borate preservative, and epoxy-fill the damaged area. That saves you money and keeps the original board. But if a pry bar sinks in more than a quarter inch, the board is structurally gone and needs replacement. We test every suspect section with a moisture meter before we recommend either path.

Is fascia and soffit repair in Surrey, North Dakota covered by insurance?

Storm-related damage is often covered. If hail or wind opened the fascia and let water in, your homeowner policy may pay for the repair minus your deductible. Gradual rot from clogged gutters or deferred maintenance is almost never covered. We document the damage with photos and a written cause assessment you can hand straight to your adjuster. We do not handle the claim for you, but we make their job easy.

Ready when you are

Get Your Fascia and Soffit Repair Surrey ND Quote Today

Soft fascia does not fix itself, and every freeze-thaw cycle makes it worse. Call +1 844-710-0795 and we will get an inspector on your roof this week. Licensed, insured, and warrantied work from a crew that lives in Ward County.

Fascia and Soffit Repair

Talk with the local team

Request Fascia and Soffit Repair

Call us at +18447100795 or email info@surreyroofrepair.com. We answer the phone 24/7 for emergencies and schedule regular inspections within one business day. If you have photos of the damage, send them over and we can often give you a ballpark before we arrive.

SurreyMain office · technicians serve the full area

Thanks — your request is in. We will contact you shortly.

Call now